SPHERIFLEX
In this bush, the outer sleeve and centre axis are spherical, which enables the bush to resist relatively high radial and axial loads and to obtain a circular rigidity which is independent of the axis of rotation.
Spherical bushes
In this bush, the outer sleeve and centre axis are spherical, which enables the bush to resist relatively high radial and axial loads.
Download PDF catalog
Related products
Other bushes
Provides a radial load capacity which is superior to that of the classic “prestressed”.
“PRESTRESSED BUSHES” with turned down sides:
For the same dimensions, this type of bush provides a radial load capacity which is superior to that of the classic “prestressed”.
In addition, versions of relatively short length permit conical movement more easily (reduced torque and increased angle).
CONICAL BUSH:
This takes the form of a rubber sleeve whose external surface is a truncated, and which surrounds a cylindrical internal part to which it adheres strongly by high radial expansion.
Assembly in pairs, in a housing made up of two truncated cones placed small end to small end.
By axial pressure, a high compression is created which ensures the external adherence of the rubber and causes lateral cushions to form at each end of the housing. These cushions ensure resistance to axial forces.
Download PDF catalog
Laminated bushes
Has a thin metallic tube between the internal tube and the external tube.
This type of bush has a thin metallic tube between the internal tube and the external tube.
The object is to have a higher stiffness radially while keeping practically the same stiffness in torsion.
Download PDF catalog
Flanged bushes
In this type of bush, one of the tubes is flanged.
In this type of bush, one of the tubes is flanged.
Download PDF catalog
Pivot bushes
This type of bush is intended to offer minimum resistance to torsion.
FLUIDBLOC
This type of bush is intended to offer minimum resistance to torsion. The elastomer is bonded to only one of the armatures, and a suitable permanent lubricant ensures the lubrication between the elastomer and the second armature ensures a very low torsional resistance.
Seal sare provided at each end to prevent the lubricant from coming out and stop impurities from getting in.
Resistance to axial force is provided by a flange in the elastomer which bears against the side of the outer sleeve, the force being transmitted by a lateral washer.