GB 530 mounts

The GB530 comprises of one part in elastomer bonded to a base plate and a tapped steel core (a nonmagnetic version is also available).

Advantages:

– Can provide high deflection under shocks.
– Long life.
– Low natural frequency (5 Hz in axial).
– Low amplification at resonance (8 at 10).

Download PDF catalog
Category:

These are specific mounts created for the naval industry: on board electronics, radars, special weapons equipment.

Related products

Evidgom®
The EVIDGOM® support can be assimilated to two thick conical membranes.

The EVIDGOM mounting is formed from two thick conical membranes, joined at their bases to create a highly elastic mounting.

There are three variations:

– All rubber EVIDGOM.
– EVIDGOM with bonded fixing.
– EVIDGOM with a diamond or square mounting plate (fixing plate supplied as a separate kit).

Download PDF catalog
Pneumatic Mounts SLM
It consists of a thick chamber of synthetic rubber.

SLM pneumatic mounts are made from synthetic rubber and are laterally reinforced with steel springs. The base plate is bored with 4 smooth holes to allow a possible fixing on the ground and the valve allows to inflate the mount in the same way as an automobile tyre.

– Elastomer body (temperature range -30ºC to +180ºC) resitant. To oils, te majority of solvents and natural ageing.
– The top and bottom plates are available in both steel and aluminium.

Download PDF catalog
Elastomer moulded parts
These parts are usually supplied in VHDS.

These parts are usually supplied in VHDS (very high density silicone) rubber and the full reference should include:

– the letter S,
– the appropriate grade which corresponds:

– to the youngs modulus of the rubber under static compression in accordance with ASTM D945 (ref. 33 to 77),
– or to the stiffness measured on a part (ref. 16 to 25).

Download PDF catalog
Disc drive suspensions
A silicone (VHDS) elastomer with a bonded metal insert.

A silicone (VHDS) elastomer with a bonded metal insert. The legs have tangs which enable each leg to be pulled through mounting holes in the equipment. The suspended component can then be attached with an M3 screw through the insert. The tangs can be cut off after insertion.