Suspension of disc drives.
Protection of electronic components and printed circuit boards with very low mass in mobile or static environments.
Disc drive suspensions
A silicone (VHDS) elastomer with a bonded metal insert. The legs have tangs which enable each leg to be pulled through mounting holes in the equipment. The suspended component can then be attached with an M3 screw through the insert. The tangs can be cut off after insertion.
Related products
Evidgom®
The EVIDGOM® support can be assimilated to two thick conical membranes.
The EVIDGOM mounting is formed from two thick conical membranes, joined at their bases to create a highly elastic mounting.
There are three variations:
– All rubber EVIDGOM.
– EVIDGOM with bonded fixing.
– EVIDGOM with a diamond or square mounting plate (fixing plate supplied as a separate kit).
Download PDF catalog
E1E11S**E* / E1E12S**E* / E1E13S**E*
VHDS elastomer able to carry loads under compression and traction.
VHDS elastomer able to carry loads under compression and traction.
Pedestal, washer and shaft in stainless steel.
Download PDF catalog
Cupmount
Está formado por un anillo de caucho adherido a dos armaduras metálicas.
The CUPMOUNT is made of rubber bonded to two metal reinforcements of truncated form.
– Interior reinforcement with tapped hole.
– External reinforcements with square base (4 holes).
Download PDF catalog
Stops
Elastic stops are quiet and avoid hammering and deterioration of equipment.
There are several types of stops:
– Cylindrical or DIABOLO stops.
– Conical progressive stops.
– LEVAFLEX progressive stops with central cavity.
– EVIDGOM stops.