This range of mounts has a stainless steel cable wound between light alloy bars. The 8010 to 8060 versions are assembled using stainless steel clips and the 8080 to 8140 models have galvanised steel screws.
There are two or four mounting holes, per bar, smooth, counter sunk or tapped.
With a natural frequency between 5 and 25 Hz, damping up to 40% and high deflection in all directions, these dampers can absorb accelerations to equipment subjected to shock or drop.
Protection of equipment in containers, protection of racks and any fragile on board equipment.
This range of shock absorbers consists of two steel soles and two high-strength metal springs, light alloy joint washers and a metal cushion in stainless steel wire on each spring. An external protective sheet prevents possible intrusions of materials that stiffen the shock absorber.
All steel parts are protected by a layer of paint. These elements are very easy to assemble and adapt to the needs of the equipment.
They comply with the ISO 9001-2000 standard.
This suspension system consists of rectangular cushions made of woven compressed stainless steel wire.
The VI786 have a Ø 9 bored screw hole, so that they can be mounted in collars with the diameters required by the user.
Fully metallic shock absorber that works with traction and compression and allows large lateral displacements.
– Springs, central axis and steel cups
– Internal elements in stainless steel wire 18/8
– Treatment: Black phosphating
– Weight: 470 gr
V118-MG and V318 mountings have cast iron cover and base with 4 mountings holes in the base and a central tapped hole in the cover.
The resilient elements are stainless steel wire mesh cushions:
– V118-MG and V318 have two cushions;
– V118-DG and V318-D have three cushions.
