Protection of electronic equipment, navigation devices, control panels, measuring instruments, control panels on airplanes, special vehicles, railroad, etc.
![vibrachoc-MV72-suspensiones-metalicas-amortiguacion-vibraciones-ruidos](https://www.vibrachoc.es/wp-content/uploads/vibrachoc-MV72-suspensiones-metalicas-amortiguacion-vibraciones-ruidos.jpg)
MV-72 / MV-73
Steel shock absorber supporting compression and pull loads.
– Shroud and base in aluminum alloy AG3. Satin finished.
– Stailess steel axle 18/8 passivated
– Stailess steel Spring and cushions 18/8
Weight (aprox):
MV-72: 60 gr
MV-73:160 gr
Download PDF catalog
Category:
Metal MountingsRelated products
The V164 and V168 dampers have a cover, an AG3 mounting plate andan AU4G shaft. The assembly is chromatised.
The upper and lower stainless steel cushions are the resilient elements of the mounting. It has four Ø 8 mounting holes on the mounting plate and one M10 tapped hole on upper cover.
Download PDF catalog
VE isolators have a cylindrical stainless steel spring, a galvanized body, an elastomer noise reduction guide and steel rings or studs depending on the model.
The VE112 series has a steel cushion inside the spring.
Download PDF catalog
V118-MG and V318 mountings have cast iron cover and base with 4 mountings holes in the base and a central tapped hole in the cover.
The resilient elements are stainless steel wire mesh cushions:
– V118-MG and V318 have two cushions;
– V118-DG and V318-D have three cushions.
Download PDF catalog
The VIBSOL mount is a simple and quick solution for machine tools offering a good shock absorption, and easy to install by sliding it under the base of the machine.
Unaffected by oils, cutting fluids, detergents, high and low temperatures with good resistance to fatigue.
It offers good stability for the suspended machine.
A constant natural frequency over a wide load range makes mount selection easy.